Powertool Direct - Power Tools

Starrett 272B RADIUS GAUGE 9/32IN - 33/64IN

Each set has an external and internal radius on each leaf permitting both concave and concave surfaces to be measured. The leaves are specially shaped for use in any position at any angle to measure fillets and radii in corners or against shoulders. Range: 9/32 - 33/64 Inch Increments: 64ths No.
Click for more information...

Starrett 257D SURFACE GAUGE

Full size surface gauge, stable steel base, fully hardened and ground with four gauge pins, frictionally held which can be pushed down for referencing the tool. Snug will hold scribers, rods or indicator stems ranging from 2.4 to 6.35mm (3/32 to 1/4 Inch).
Click for more information...

Starrett 272MA RADIUS GAUGE 0.75-5MM

Each set has an external and internal radius on each leaf permitting both concave and concave surfaces to be measured. The leaves are specially shaped for use in any position at any angle to measure fillets and radii in corners or against shoulders. Range: 0.75 - 5mm Increments: 0.25mm No.
Click for more information...

MITUTOYO 2046S DIAL INDICATOR 0.01MM GRAD

Designed to be attached to machinery jigs and fixtures the contract point detects the slightest deviation which is registered on the dial of the indicator. Measuring range :- 10mm Graduation :- 0.
Click for more information...

MONUMENT 1510F MAINS WATER PRESSURE GAUGE

Mains water pressure gauge with 3/4in BSP thread fitting to taps. Maximum to 11 bar.
Click for more information...

MITUTOYO 2047S DIAL INDICATOR 0.01MM GRAD

Designed to be attached to machinery jigs and fixtures. The contact point detects the slightest deviation which is registered on the dial of the indicator. Measuring range :- 10mm Graduation :- 0.
Click for more information...

Starrett 237M DEPTH GAUGE 150MM

Can be used to quickly obtain measurements in 1/2mm or 64th of an inch by adjusting the rule to the required depth. The gauge consists of a hardened steel head complete with locking nut and an accurate, machine divided, tempered steel rule.
Click for more information...

F/PRINT 1258 MARKING GAUGE

Used for marking wood parallel to the edge prior to sawing or chiselling. The bottom edge of the stem is shaped to enable it to slide easily over the timber being marked. The Gauge is made from selected beechwood and fitted with a hardened steel pin and plastic thumbscrew.
Click for more information...

Starrett 272A RADIUS GAUGE 1/32IN - 17/64IN

Each set has an external and internal radius on each leaf permitting both concave and concave surfaces to be measured. The leaves are specially shaped for use in any position at any angle to measure fillets and radii in corners or against shoulders. Range: 1/32 - 17/64 Inch Increments: 64ths No.
Click for more information...

Faithfull HARDWOOD MORTICE GAUGE - SLIDE ADJ

This dual purpose Gauge is Hardwood and used for laying out mortices and for marking out with the grain. The second pin is used for mortice work can be accurately set by means of the pullslide.
Click for more information...